User Manual
Table Of Contents
- Information
- About Yamaha LAN Monitor
- Contents
- Terminology
- Steps to use the software
- Software operating requirements
- Notes
- Notes regarding device detection
- Notes regarding SWX2100/SWR2100P series PoE switch detection
- Notes regarding the power supply interruption function for the Yamaha PoE switch
- Notes regarding a slave with the stack function enabled
- Notes on printing and print preview of the “Whole map”
- Notes regarding detection of Dante-enabled devices
- Installing and uninstalling Yamaha LAN Monitor
- Starting and exiting Yamaha LAN Monitor
- Yamaha LAN Monitor screen structure
- Network settings on the computer
- Basic operation
- Menu bar
- Toolbar and display area
- Map screen
- List screen
- Configuring the device
- Update the firmware
- Import/Export the CONFIG
- Troubleshooting
Resources
Yamaha LAN Monitor for Win User Guide
61
Execution result of firmware/CONFIG bulk operation
The following are the execution results displayed when executing bulk firmware update and bulk CONFIG import/
export.
Shortcut keys
Shortcut keys used in Yamaha LAN Monitor are as follows.
Result Descriptions
Completed
The firmware update and CONFIG import/export processes have been
completed successfully.
Only transfer completed
(revision acquisition failed)
The firmware file transfer was completed but the updated firmware revision
could not be retrieved, so the firmware may not have been applied correctly.
Check the application status of the firmware separately.
Only transfer completed
(revision mismatch)
The transfer of the firmware file is complete, but the revision of the transferred
firmware file and the updated firmware revision are different.
Check the application status of the firmware separately.
Only transfer completed
(File revision unknown)
The transfer of the firmware file was completed, but it was not confirmed that the
firmware was applied correctly because the revision of the transferred firmware
file was incorrect.
Check the application status of the firmware separately.
Skip
The firmware update was not performed because the revision of the firmware
file you tried to transfer had already been applied.
Aborted
Firmware update or CONFIG import/export has been canceled by user
operation.
Failed (Timeout)
A timeout occurred and the transfer of firmware or CONFIG failed.
Check the connectivity of the device.
Failed (Application error)
An application error has occurred and the transfer of firmware or CONFIG has
failed.
Failed (Busy)
The transfer of firmware or CONFIG failed because other processes are running
on the device.
Failed (Invalid file)
The transfer of firmware or CONFIG failed because the selected file was invalid.
Failed (CONFIG doesn’t exist)
The CONFIG did not exist on the device where you tried to export the CONFIG.
The CONFIG of the device may have been deleted, or it may be in a factory
default state.
Failed (Timeout)
Transfer of firmware or CONFIG failed due to reasons other than the above.
Result Key operation
Edit a cell in a list F2
Update the connection status of the currently selected slave F5