User Manual
Table Of Contents
- Yamaha LAN Monitor for Mac
- Table of contents
- 1. Introduction
- 2. Installing and uninstalling Yamaha LAN Monitor
- 3. Starting and exiting Yamaha LAN Monitor
- 4. Yamaha LAN Monitor screen structure
- 5. Network settings on the computer
- 6. Basic operation
- 7. Menu bar
- 8. Toolbar and display area
- 9. Map screen
- 10. List screen
- 11. Configuring the device
- 12. Update the firmware
- 13. Import/Export the CONFIG
- 14. Resources
- 15. Troubleshooting
- Yamaha LAN Monitor for Mac
❶ Device Details
This area shows the following information. Depending on the device, some items will not be
shown.
“Label” Shows the device label that was entered in the “Device Settings”
dialog box or the “Connected Devices” view.
“Model name” Shows the model name of the device.
“Comment” Shows the comment that was entered in the “Connected Devices”
view. You can freely enter information about the on-site cabling
or the role of the device.
“Manufacturer” Shows the manufacturer name of the device.
“IP address” Shows the IP address of the device. The IP address of the device
can be changed in the “Device Settings” dialog box. This field is
left blank for devices without an IP address.
“MAC address” Shows the MAC address of the device.
“Serial” Shows the serial number of the device.
“Firmware” Shows the firmware revision of the device.
“Snapshot function” Shows whether the device is monitored by the Snapshot function
(On) or not monitored (Off).
“EEE” Shows whether the power-saving function is enabled or disabled.
This shows either Economy Mode or Normal Mode for SWX2200
series devices.
“Fan Status” For a switch with a built-in fan, shows whether the fan is
operating normally or malfunctioning.
“Fan RPM” Shows the fan RPM for a switch with a built-in fan.
“Internal temperature” Shows the internal temperature of the switch.
“Sum of power might be
supplied”
Shows the sum of the maximum power capacity supplied to the
switch-connected device. Note that the power supply may be
interrupted, depending on the condition, if this value exceeds the
limitation of the maximum power supply capacity for the PoE
switch.
“Power being supplied” Shows the total power supplied from each port on the switch and
from the entire device.
“Link aggregation” Shows the link aggregation type.
❷ Port status
This area shows a graphic representation of information concerning the Yamaha switch and
Dante-enabled devices. Use the tabs located below the graphic to switch the information that is
shown.
• [Port Status] tab: Shows the connection status and communication speed of each port.
• [Bandwidth(%)] tab: Shows the bandwidth usage of each port. (For switches only)
• [PoE status (Class)] tab: This area shows the power supply status for each port. (For PoE-
enabled switches only)
9. Map screen
32 | Yamaha LAN Monitor for Mac User Guide