User Manual

11.1.1. For non-SWX2110/SWX2110P/SWX2200 series Yamaha switch and
Yamaha wireless LAN access point
Basic items such as label settings, device name settings, and IP address settings can be configured.
Only items that are supported by the device will be displayed.
[Include in a snapshot]
check box
Turns the snapshot function on/off for each device. For an agent device,
this is fixed on.
This item will be displayed for all devices.
“Label Settings”
You can enter any label or comments you like to identify each device.
Since the labels and comments you set will only be used within LAN Monitor,
this information can be associated with the device without changing the
settings of the device itself.
This item will be displayed for all devices.
“Device name settings”
Click the [Set] button to display the “Device name settings” dialog.
The device name you set in “Device name settings” will be saved in the
device itself.
“IP address settings” Click the [Settings] button to display the “IP address settings” dialog box.
[Update firmware from
PC] button
Click the [Update firmware from PC] button to display the “Update
firmware from PC” dialog box.
“Config
Import/Export”
Click the [Import] button to display the “CONFIG import” dialog.
Click the [Export] button to display the “CONFIG export” dialog.
[Close] button
When you click this, the “Device Settings” dialog box closes.
This item will be displayed for all devices.

NOTE
Some items will not be displayed until the firmware revision is acquired.
If some items are not displayed, please wait for a while and then open the Device
Settings dialog again.
11. Configuring the device
48 | Yamaha LAN Monitor for Win User Guide