User Manual

Setting value Description
manager
Operate as an L2MS manager that sets and
controls SWR series or SWX series units that are
connected subordinate to it
agent
Be managed from a Yamaha device that is
operating as an L2MS manager, such as a router,
firewall, or SWX series unit that is set as the
L2MS manager
[Initial value]
l2ms role agent
[Input mode]
L2MS mode
[Description]
Sets the role when using the L2MS function.
If this command is executed with the "no" syntax, operate as a agent.
[Note]
If the same network includes multiple Yamaha routers or firewalls on which L2MS (switch controller function) is enabled, or
multiple SWX series units that are set to be L2MS managers, the L2MS function will not operate correctly.
Ensure that a single network has only one device that is the L2MS manager.
[Example]
Use the L2MS function as manager.
SWR2310(config)#l2ms configuration
SWR2310(config-l2ms)#l2ms enable
SWR2310(config-l2ms)#l2ms role manager
4.23.4 Set L2MS agent watch interval
[Syntax]
agent-watch interval time
no agent-watch interval
[Parameter]
time : <2-10>
Watch interval (seconds)
[Initial value]
agent-watch interval 3
[Input mode]
L2MS mode
[Description]
Specifies the time interval at which to transmit an L2MS agent query frame.
If this command is executed with the "no" syntax, the setting returns to the default.
If you set time to a high value, the query frame is transmitted less often, but it will take longer from when the L2MS agent is
connected until the L2MS manager recognizes it. If you set time to a low value, the opposite will be the case; the query frame is
transmitted more often, but it will take less time from when the L2MS agent is connected until the L2MS manager recognizes it.
[Note]
L2MS agent watch is performed only if L2MS is operating as manager.
[Example]
Set the watch interval to five seconds.
SWR2310(config)#l2ms configuration
SWR2310(config-l2ms)#l2ms enable
Command Reference | Maintenance and operation functions | 115