User Manual

[Note]
This command cannot be specified for the following interfaces.
• VLAN interface
• A physical interface inside a logical interface
A physical interface inside a logical interface operates according to the setting of this command on the interface inside which it
exists. If the physical interface is inside the logical interface, the setting of the physical interface returns to the default.
Regardless of the setting of this command, L2MS control frames might not be transmitted or received if any of the following
conditions exist.
• The interface is in the Blocking status due to STP or the loop detection function
• The switchport trunk native vlan none command has been specified
• It is inside a logical interface
[Example]
Prevent port1.5 from transmitting or receiving L2MS control frames.
SWR2310(config)#interface port1.5
SWR2310(config-if)#l2ms filter enable
4.23.9 Reset agent management
[Syntax]
l2ms reset
[Input mode]
privileged EXEC mode
[Description]
Removes all L2MS agents managed by the L2MS manager from management, and searches for L2MS agents once again.
[Note]
This can be executed only if L2MS is operating as manager.
When this command is executed, L2MS agents that were being managed also remove themselves from the state of being
managed by the L2MS manager.
After this command is executed, the timing at which L2MS agent watching resumes will depend on the time specified by the
agent-watch interval command.
[Example]
Reset L2MS agent management.
SWR2310#l2ms reset
4.23.10 Show L2MS information
[Syntax]
show l2ms [detail]
[Keyword]
detail : Also show detailed information
[Input mode]
unprivileged EXEC mode, privileged EXEC mode
[Description]
Shows the following information according to the L2MS operating state.
• If L2MS is operating as manager
• Number of L2MS agents being managed
• Information for the L2MS agents being managed
• MAC address
• Model name
• Device name
• Route
• Uplink port
• Settings applied
118 | Command Reference | Maintenance and operation functions