User Manual

Attaching the legs

20 SWR2310-28GT SWR2310-18GT SWR2310-10G

Attaching the legs

As shown in the illustration, attach the included legs in the positions of the leg attachment

guides, and place the unit on a level location such as a desk.

Installation in a rack

Please read before mounting the unit into a rack

• This unit is warrantied to operate in an ambient temperature range of 0–50 °C. If you

install this unit along with other devices into an EIA-standard or JIS-standard rack,

the temperature inside the rack may rise due to heat released from the other

devices, resulting in poor performance of the unit. To prevent the temperature inside

the unit from rising, mount the unit in the rack in accordance with the requirements

below.

• If you plan to rack-mount the unit along with a device that tends to generate heat,

such as an amplifier (excluding an XMV series), be sure to leave a gap of 1U or

more from such devices. Also, be sure to maintain sufficient ventilation in this space

by installing a ventilation panel or leaving it open.

• Open the rear panel of the rack, and place the rack at least 10cm (about four

inches) away from the walls and ceiling to ensure sufficient ventilation. If you cannot

open the rear panel of the rack, install a commercially-available forced ventilation

device, such as a fan kit. If you install a fan kit, closing the rear panel may work

better for heat dissipation purposes. For more information, refer to the owner’s

manual for the rack and/or fan kit.

Caution

If you plan to relocate the rack, be sure to first remove this unit from the rack.

If you move the unit while it is still installed in the rack, vibration or physical shock might deform

or damage the rack mount accessory or rack mount hardware, causing injury. There is also a

possibility that this unit might malfunction.

2 4 6 8 10 12 14 16

1357911 1315

Leg

Leg attachment guides