User Manual

English
Installation in a rack
SWR2310-28GT SWR2310-18GT SWR2310-10G
21
° Installing in a 19-inch rack
The SWR2310-10G is installed using an RK-SWR rack mount accessory sold separately by
Yamaha.
Installation
This section explains how to attach the unit in the middle block of a rack mount panel.
Even if you plan to attach the unit in the left or right block, follow the procedure below.
Notice
If the supplied feet have already been attached to the unit, remove them.
1. Attaching the rack mount panel to the unit
Use the two screws supplied with the rack-mount accessory, attach the rack mount panel to
the bottom panel of the unit.
SWR2310-10G
Warning
When attaching this unit to the separately
sold RK-SWR rack mount accessory, you
must use the specified screws that are
included with the rack mount accessory.
If the unit falls, injury or damage might occur.
This could also cause electric shock or
malfunctions.
10
9
Rack mount panel
Screws
Use a Phillips screwdriver
to firmly fasten the screws.