User Manual

English
Installation in a rack
SWR2310-28GT SWR2310-18GT SWR2310-10G
23
° Installing in a 19-inch rack
The SWR2310-28GT and SWR2310-18GT fit in a 19-inch rack mount 1U size. When installing
them in a 19-inch rack, attach the included rack mount hardware (2 pcs.) using the included
screws (8 pcs.). Here we explain using the SWR2310-28GT as an example.
Warning
You must use the included rack mount hardware and screws.
If the unit falls, injury or damage might occur. This could also cause electric shock or malfunctions.
Notice
• If the rack cabinet has a door, take care that it will not interfere with communication cables
or the power cord after this unit is installed.
• So as not to obstruct the cooling vents on the side panels of this unit, leave a gap when
installing it in a 19-inch rack.
Memo
Using the screws that are included with the 19-inch rack (EIA standard 4 pcs., JIS standard 2 pcs.),
fasten this unit to the rack.
The rack mount hardware can be attached to this unit using either of the following two
methods.
Method A : Attach the rack mount
hardware so that its rack
screw surface is flush with
the front panel of this unit
Method B : Install the unit 4 cm deeper
than method A (recessed)
If the 19-inch rack cabinet has
a door, use this method of
attachment. Install the unit in a
recessed position so that
cables inserted in the front
panel of the unit do not contact
the door of the rack.
/
SWR2310-28GT
SWR2310-18GT
2 4 6 8 1
0 1
2 1
4
1
6
2
6
1
3
5 7
9
1
1
1
3 1
5
1
8
1
7
2
0
1
9
2
2
2
1
2
4
2
3
2
5
2
8
2
7
Use a Phillips screwdriver to firmly fasten the screws.