User Manual

Installation on a wall or ceiling
24 SWR2310-28GT SWR2310-18GT SWR2310-10G
Installation on
a wall or ceiling
Use the separately sold WK-SWR wall mount accessory to install the unit.
If attaching this unit to a ceiling, invert the top and bottom of the unit.
You will need to obtain six screws that fit the holes described in step 1 and are appropriate for
the material and thickness of the wall or ceiling.
Carry out the installation completely, all the way to step 7.
Here we explain using mainly the SWR2310-10G as an example.
Caution
• Do not attach this unit to a wall or ceiling that is higher than 2 meters.
If the unit falls, injury or damage might occur.
• When attaching or removing this unit, you must disconnect the unit’s power
plug from the power outlet.
Failing to do so could cause electrical shock or malfunctions.
• Installation must be performed by a qualified installer.
During installation, pay attention to the following points.
• Choose hardware and a location that is well able to support the weight of this unit
• Avoid locations that are subject to sustained vibration
• You must use the specified installation accessory
• Perform periodic maintenance checks
Notice
• The mounting accessory has a surface to which the SWR2310-18GT/SWR2310-10G must
be attached and a surface that must be attached to the wall or ceiling.
If these two surfaces are confused, it will not be possible to attach the mounting accessory
to the SWR2310-18GT/SWR2310-10G. To distinguish the surfaces, refer to the illustrations
for step 1 and step 3.
• The position of the unit relative to the mounting accessory differs by 90 degrees between
the SWR2310-18GT and the SWR2310-10G.
/
SWR2310-18GT
SWR2310-10G
2
4 6 8
1
3 5 7
10
9
2 4 6
8 1
0 1
2
1
41
6
1
8
1
3 5 7 9 1
1 1
3 1
5
1
7
SWR2310-18GT SWR2310-10G