User Manual

English
Settings
SWR2310-28GT SWR2310-18GT SWR2310-10G
27
Settings
Settings for this unit can be made in the following ways.
• Make settings using the Web GUI
• Make settings from the command line using the CONSOLE port
• Make settings from the command line using Telnet
• Make settings from the command line using SSH
This document explains “Make settings using the Web GUI” (page 28) and “Making settings
from the command line using the CONSOLE port” (page 29).
You can log in to this unit either as a standard user or as an administrative user. This
document explains how to log in as an administrative user.
Different users are permitted to log in depending on the firmware used. If the product is
configured with factory settings, then the following users can log in.
The rest of this chapter describes the login procedure when using Rev. 2.04.11 or a later
version of firmware is used.
Notice
If the firmware is updated from Rev. 2.04.10 or earlier to Rev. 2.04.11 or later while operating
the product, then the user settings might be updated automatically in some cases.
• If updated with no administrative user registered:
The initial administrative user name “admin” is automatically added, which requires
entering “admin” to log in the first time.
• If updated with no user password specified:
Login is possible using the same password as the user name. (For security reasons, the
password should be changed after login.)
For more details, refer to the SWR2310 series “Technical Reference”.
For details on the commands used by this unit, refer to the command reference.
The command reference is available on the Yamaha website.
https://www.yamahaproaudio.com/
Firmware User (Given Factory Settings) Remarks
Rev. 2.04.11 or later
Initial administrative user name
“admin”
(initial password “admin”)
After logging in, the password must
be changed to something other than
“admin”.
Rev. 2.04.10 or earlier
Unnamed user
(both the user name and password
fields are blank)