User Manual

English
Settings
SWR2310-28GT SWR2310-18GT SWR2310-10G
29
Here we explain the cable, driver, software, and settings that are necessary in order to use the
CONSOLE port.
° Preparing a console cable
• Connect the computer to the CONSOLE port of this unit using a USB cable or an
RJ-45/DB-9 console cable.
• As the USB cable connected to the mini-USB CONSOLE port, use a USB cable that
is equipped with a USB Type A connector and a USB mini-B (5-pin) connector, and
that supports data communication. Charge-only cables cannot be used.
° Installing the USB serial driver
• In order to use the mini-USB CONSOLE port, the USB serial driver must first be
installed in the computer.
• For details on installing the USB serial driver, refer to the “Yamaha Network Device
USB Serial Driver Installation Guide.”
The Yamaha Network Device USB Serial Driver Installation Guide and the installer can be
downloaded from the Yamaha website.
https://www.yamahaproaudio.com/
° Preparing the computer
You will need terminal software that controls the serial (COM) port of the computer.
Set the parameters of the terminal software as follows.
If the computer is connected to both the RJ-45 CONSOLE port and the mini-USB
CONSOLE port, only the terminal software that uses the mini-USB CONSOLE port can
make settings.
The messages that are output from this unit are output to both CONSOLE ports.
Making settings from the command line using the
CONSOLE port
Parameter Value
Data transmission speed 9600 bps
Character bit length 8
Parity check None
Number of stop bits 1
Flow control Xon/Xoff