User Manual

Initialization
36 SWR2310-28GT SWR2310-18GT SWR2310-10G
Initialization
This unit can be restored to its factory-set state in the following ways.
• Using the Web GUI to restore the factory settings (page 36)
• Using the cold start command to restore the factory settings (page 37)
• Entering the [I] (uppercase I) key during startup to restore the factory settings (page 38)
Notice
When restoring the factory settings, note the following points.
• All communication is halted immediately after execution.
• When you execute this, the settings will also return to their factory-set state. If necessary,
use external memory to save the settings before you proceed with initialization. For details
on how to export settings to external memory, refer to the SWR2310 series “Technical
Reference.”
Memo
For login instructions after restoring factory settings, see “Settings” (page 27).
° Using the Web GUI to restore the factory settings
This unit can be restored to its factory-set state by making settings from the Web GUI.
Notice
This step cannot be executed if the initial administrative password is specified. Change the
administrative password in advance.
Log in to the Web GUI from Yamaha LAN Monitor.
1. Choose “Administration” tab – “Maintenance” – “Restart or Initialize.”
The “Restart or Initialize” screen appears.
2. In the “Initialize” section, click the “Proceed” button.
The “Initialize” screen appears.
3. Enter the administrative password, and click “Confirm.”
The “Confirm execution” screen appears.
4. Verify the content, and click the “Execute” button.
The unit is returned to its factory-set state. Also, the “Initialization” dialog box appears, and
the unit restarts.
5. After this unit has finished restarting, access the Web GUI once again from
Yamaha LAN Monitor.
Memo
During restart, the computer on which the Web GUI is open will be unable to communicate with the
unit (the status indication of the computer’s network adapter will be “Network cable is not
connected”), but the communication status will recover when restart is completed. After this unit’s
POWER indicator has finished flashing, verify that communication has been restored for the
computer on which the Web GUI is open, and then click the “Web GUI” button in the “Device
Details” view.