User Manual

Initialization
38 SWR2310-28GT SWR2310-18GT SWR2310-10G
° Entering the [I] (uppercase I) key during startup to restore the factory
settings
The unit can be restored to its factory settings by entering an uppercase “I” when the unit
is starting up. This explanation uses the method of disconnecting and reconnecting the
power cord. The procedure is also the same when using the reload command to restart
this unit.
Notice
Here we assume that you are logged in as described in “Logging in from a computer
connected to the CONSOLE port” (page 30).
1. Disconnect and then reconnect the power cord of this unit.
2. After restart, enter an uppercase “I” within one second after the BootROM
Ver (see below) appears on the console screen.
Memo
Before the BootROM Ver appears on the console screen, you can press the [Caps Lock] key or
hold down the [Shift] key so that you will be ready to enter an uppercase “I” immediately.
3. When a screen asks you whether to execute initialization, press the <y> key
to execute initialization.
Initialization is executed.
SWR2310 BootROM Ver.1.00
Initialize or not ?(y/n)
Ready to Initialize
...............