User Manual

9.1.15 Set VLAN access map filter ....................................................................................................247
9.1.16 Show VLAN access map .........................................................................................................247
9.1.17 Show VLAN access map filter ................................................................................................248
9.2 QoS (Quality of Service) ..........................................................................................................................248
9.2.1 Enable/disable QoS ...................................................................................................................248
9.2.2 Set default CoS ..........................................................................................................................249
9.2.3 Set trust mode ............................................................................................................................249
9.2.4 Show status of QoS function setting .........................................................................................250
9.2.5 Show QoS information for interface .........................................................................................250
9.2.6 Show egress queue usage ratio ..................................................................................................252
9.2.7 Set CoS - egress queue ID conversion table ..............................................................................252
9.2.8 Set DSCP - egress queue ID conversion tabl ............................................................................253
9.2.9 Set port priority order ................................................................................................................254
9.2.10 Specify egress queue of frames transmitted from the switch itself .........................................255
9.2.11 Generate class map (traffic category conditions) ....................................................................255
9.2.12 Associate class map .................................................................................................................256
9.2.13 Set traffic classification conditions (access-list) .....................................................................256
9.2.14 Set traffic classification conditions (CoS) ...............................................................................257
9.2.15 Set traffic classification conditions (TOS precedence) ...........................................................257
9.2.16 Set traffic classification conditions (DSCP) ............................................................................258
9.2.17 Set traffic classification conditions (Ethernet Type) ...............................................................258
9.2.18 13.2.22 Set traffic classification conditions (VLAN ID) ........................................................259
9.2.19 Set traffic classification conditions (VLAN ID range) ............................................................259
9.2.20 Show class map information ...................................................................................................260
9.2.21 Generate policy map for received frames ................................................................................261
9.2.22 Apply policy map for received frames ....................................................................................261
9.2.23 Set pre-marking (CoS) .............................................................................................................262
9.2.24 Set pre-marking (TOS precedence) .........................................................................................263
9.2.25 Set pre-marking (DSCP) ..........................................................................................................264
9.2.26 Set individual policers (single rate) .........................................................................................264
9.2.27 Set individual policers (twin rate) ...........................................................................................266
9.2.28 Set remarking of individual policers .......................................................................................267
9.2.29 Generate aggregate policer ......................................................................................................268
9.2.30 Set aggregate policer (single rate) ...........................................................................................269
9.2.31 Set aggregate policer (twin rate) ..............................................................................................270
9.2.32 Set remarking of aggregate policers ........................................................................................271
9.2.33 Show aggregate policers ..........................................................................................................272
9.2.34 Apply aggregate policer ..........................................................................................................272
9.2.35 Show metering counters ..........................................................................................................273
9.2.36 Clear metering counters ...........................................................................................................274
9.2.37 Set egress queue (CoS-Queue) ................................................................................................274
9.2.38 Set egress queue (DSCP-Queue) .............................................................................................275
9.2.39 Show policy map information .................................................................................................275
9.2.40 Show map status ......................................................................................................................277
9.2.41 Set egress queue scheduling ....................................................................................................278
9.2.42 Set traffic shaping (individual port) ........................................................................................279
9.2.43 Set traffic-shaping (queue units) .............................................................................................279
9.3 Flow control ..............................................................................................................................................280
9.3.1 Set flow control (IEEE 802.3x PAUSE send/receive) (system) ................................................280
9.3.2 Set flow control (IEEE 802.3x PAUSE send/receive) (interface) .............................................281
9.3.3 Show flow control operating status ...........................................................................................281
9.4 Storm control ............................................................................................................................................282
Command Reference | TOC | 11