User Manual

[Parameter]
hour : <0-23>
Firmware update reload time (hour)
min : <0-59>
Firmware update reload time (minutes)
[Input mode]
global configuration mode
[Description]
Sets the time at which the new firmware is applied by restarting after a firmware update.
If this command is executed with the "no" syntax, the new firmware is applied by restarting immediately after the firmware is
updated.
[Example]
Specify AM 1:30 as the restart time for updating the firmware.
SWR2310(config)#firmware-update reload-time 1 30
SWR2310(config)#
4.23.8 Set reload method for firmware update of stack configuration
[Syntax]
firmware-update reload-method method
no firmware-update reload-method
[Parameter]
method : Firmware update reload method
Setting value Description
normal Reload stack master and slaves simultaneously
sequential Reload stack master and slaves sequentially
[Initial value]
firmware-update reload-method normal
[Input mode]
global configuration mode
[Description]
Sets the method of restarting after a firmware update when using a stack configuration.
"normal" restarts the master and slaves simultaneously. With the "sequential" setting, the master finishes restarting, and then the
slaves are restarted, thereby applying the new firmware in a way that does not affect the currently-operating network service.
If this command is executed with the "no" syntax, the setting returns to the default.
[Note]
This command can be specified only when the stack function is enabled.
[Example]
Specify sequential as the restart method of updating the firmware.
SWR2310(config)#firmware-update reload-method sequential
SWR2310(config)#
4.24 Stack
4.24.1 Set stack function
[Syntax]
stack switch
no stack
118 | Command Reference | Maintenance and operation functions