User Manual

[Parameter]
switch : Operation of the stack function
Setting value Description
enable Enable stack function
disable Disable stack function
[Initial value]
stack disable
[Input mode]
global configuration mode
[Description]
Enables or disables the stack function.
If this command is executed with the "no" syntax, the setting returns to the default.
[Note]
This command can be executed only for models that support stacking.
If the unit started up using the config saved on the SD card, and the SD card is subsequently unmounted, executing this
command produces an error.
[Example]
Enable stack function.
SWR2310(config)#stack enable
Disable stack function.
SWR2310(config)#stack disable
4.24.2 Change ID of stack member
[Syntax]
stack stack_id renumber new_stack_id
[Parameter]
stack_id : <1-2>
Stack member ID to be changed. If a non-existent ID is specified, an error results
new_stack_id : <1-2>
Stack member ID after change
[Initial value]
none
[Input mode]
global configuration mode
[Description]
Changes the ID of the specified stack member.
[Note]
This command can be executed only for models that support stacking.
This command can be executed only if the stack function is disabled.
Only one's own stack member ID can be changed.
If the unit started up using the config saved on the SD card, and the SD card is subsequently unmounted, executing this
command produces an error.
[Example]
Change the ID:1 stack member to ID:2.
SWR2310(config)#stack 1 renumber 2
Command Reference | Maintenance and operation functions | 119