User Manual

[Example]
Show VLAN access map information.
SWR2310>show vlan access-map
Vlan access-map VAM001
match ipv4 access-list 2
9.1.17 Show VLAN access map filter
[Syntax]
show vlan filter
[Input mode]
unprivileged EXEC mode, privileged EXEC mode
[Description]
Show VLAN access map filter application information.
The following items are shown.
• Name of the VLAN access map
• VLAN ID applied to VLAN access map
• Frame direction (in/out) for which a VLAN access map is applied
[Example]
Show VLAN access map filter information.
SWR2310>show vlan filter
Vlan Filter VAM001 is applied to vlan 1000 in
Vlan Filter VAM001 is applied to vlan 1001 out
Vlan Filter VAM002 is applied to vlan 2000-2001 in
9.2 QoS (Quality of Service)
9.2.1 Enable/disable QoS
[Syntax]
qos action
qos_disable
[Parameter]
action : Operation for Qos
Setting value Description
enable Qos is enabled
disable Qos is disabled
[Initial value]
no qos
[Input mode]
global configuration mode
[Description]
Enables QoS.
If this is executed with the "no" syntax, QoS is disabled. At this time, the related QoS settings are also deleted.
[Note]
If the flow control system setting is enabled, it is not possible to enable QoS.
Many of the commands related to QoS cannot be executed unless QoS is left enabled.
[Example]
Enable QoS.
SWR2310(config)#qos enable
Disable QoS.
248 | Command Reference | Traffic control