User Manual

Setting value Description
1 Use only upper threshold value (risingAlarm)
2 Use only lower threshold value (fallingAlarm)
3
Use both upper threshold value and lower
threshold value (risingOrFallingAlarm)
(if omitted : 3)
owner : Name of alarm group owner (alarmOwner)
maximum 127 characters
(if omitted : RMON_SNMP)
[Initial value]
none
[Input mode]
global configuration mode
[Description]
Enables the RMON alarm group settings.
Set variable as the MIB object that will be the target of monitoring by the RMON alarm group. Of the etherStatsEntry(.
1.3.6.1.2.1.16.1.1.1) MIB objects, variable can be specified only as a MIB object that has a counter type. This can be specified
in the following three formats.
• etherStatsEntry.X.Y
• (OID name under etherStatsEntry).Y
• .1.3.6.1.2.1.16.1.1.1.X.Y
For example, if specifying etherStatsPkts.1(.1.3.6.1.2.1.16.1.1.1.5.1), it can be specified in any of the following formats.
Format Description
etherStatsEntry.X.Y etherStatsEntry.5.1
(OID name under etherStatsEntry).Y etherStatsPkts.1
.1.3.6.1.2.1.16.1.1.1.X.Y .1.3.6.1.2.1.16.1.1.1.5.1
You can use a format that specifies either rising_threshold or falling_threshold, not both. In this case, the following values are
used for parameters whose setting is omitted.
• Use only rising_threshold
• falling_threshold : Same value as rising_threshold
• falling_event_index : Same value as rising_event_index
• startup : 1 (Use only upper_threshold)
• Use only falling_threshold
• rising_threshold : Same value as falling_threshold
• rising_event_index : Same value as falling_event_index
• startup : 2 (Use only lower_threshold)
If this command is set, it will be possible to acquire the RMON MIB's alarmTable.
If this command is executed with the "no" syntax, the setting value is deleted.
[Note]
To enable the alarm group setting of the RMON function, it is necessary to enable the system-wide RMON function in addition
to this command.
The MIB object specified in variable is a MIB object of the Ethernet statistical information group. If an Ethernet statistical
information group possessing the applicable index has not been created, this command returns an error.
The Ethernet statistical information group can be created by the rmon statistics command. If the Ethernet statistical
information group being used by this command is deleted, this command is also deleted.
The event index specifies the index that is set by the rmon event command. If the event group being used by this command is
deleted, this command is also deleted.
The rising_threshold value must be a higher value than the falling_threshold value.
If this command is overwritten, the previous sampling data is deleted, and sampling is once again started.
64 | Command Reference | Maintenance and operation functions