User Manual
Table Of Contents
- Information
- About Yamaha LAN Monitor
- Contents
- Terminology
- Steps to use the software
- Software operating requirements
- Notes
- Notes regarding device detection
- Notes regarding SWX2100/SWR2100P series PoE switch detection
- Notes regarding the power supply interruption function for the Yamaha PoE switch
- Notes regarding a slave with the stack function enabled
- Notes on printing and print preview of the “Whole map”
- Notes regarding detection of Dante-enabled devices
- Notes regarding when using macOS10.15.x or later
- Installing and uninstalling Yamaha LAN Monitor
- Starting and exiting Yamaha LAN Monitor
- Yamaha LAN Monitor screen structure
- Network settings on the computer
- Basic operation
- Menu bar
- Toolbar and display area
- Main screen
- Web GUI
- Resources
- Troubleshooting
Main screen
Yamaha LAN Monitor for Mac User Guide
29
1 Sorting order reference node selection pull-down menu
Selects the Yamaha switch that you want to appear at the top of the tree view. These are shown in their
connection order relative to the selected Yamaha switch.
NOTE
• Only the Yamaha switch for the current network will appear in the sorting order reference node selection pull-down menu.
• When starting Yamaha LAN Monitor, the Yamaha switch closest to the computer will serve as the starting point for the tree
view.
2 Tree view
This area shows the Yamaha switch, and Dante-enabled devices detected by Yamaha LAN Monitor.
If a device that was recorded in the snapshot is no longer found, or if the connection port is different, a red error
icon ( ) is shown for the slave that is above the corresponding device. If a device that was not recorded
previously is newly found, a blue notification icon ( ) appears on the slave that is above the corresponding
device.
1
2