User Manual
Table Of Contents
- Information
- About Yamaha LAN Monitor
- Contents
- Terminology
- Steps to use the software
- Software operating requirements
- Notes
- Notes regarding device detection
- Notes regarding SWX2100/SWR2100P series PoE switch detection
- Notes regarding the power supply interruption function for the Yamaha PoE switch
- Notes regarding a slave with the stack function enabled
- Notes on printing and print preview of the “Whole map”
- Notes regarding detection of Dante-enabled devices
- Installing and uninstalling Yamaha LAN Monitor
- Starting and exiting Yamaha LAN Monitor
- Yamaha LAN Monitor screen structure
- Network settings on the computer
- Basic operation
- Menu bar
- Toolbar and display area
- Main screen
- Web GUI
- Resources
- Troubleshooting
Toolbar and display area
Yamaha LAN Monitor for Win User Guide
17
Toolbar and display area
This section describes the display area and each button on the toolbar: [Device search], [Snapshots], [Notifications],
[History], [Whole map] and [Dante Controller].
1 Network adapter selection pull-down menu (page 17)
2 [IP Address (PC)] (page 17)
3 [Device search] button (page 17)
4 [Snapshots] button (page 19)
5 [Notifications] button (page 19)
6 [History] button (page 20)
7 [Whole map] button (page 20)
8 [Dante Controller] button (page 22)
Network adapter selection pull-down menu
Select the network adapter to be monitored by Yamaha LAN Monitor from the pull-down menu.
If you change the network adapter, the snapshot internally held in Yamaha LAN Monitor is discarded.
NOTE
Network adapters that have been disabled on a PC running Yamaha LAN Monitor will not appear.
When Yamaha LAN Monitor is started, the network adapter specified as the Dante shared interface is selected.
If the Dante Discovery/Dante Control and Monitoring function or Dante Controller is not installed, the network adapter that was
selected when you last exited will be used.
If you change the network adapter selection, Dante-enabled devices may not be detected, but restarting Yamaha LAN Monitor
will allow them to be detected normally.
[IP Address (PC)]
Indicates the IP address that is assigned to the currently selected network adapter.
[Device search] button
Opens the “Device search” dialog box. This function can use specified IP addresses to ping devices that are
connected to the current network. This function also can search the IP addresses of all devices that are connected
to the current network.
If the “Connected Devices” view does not list some devices on which you want to perform keepalive checks (life/
death monitoring), you can execute this function to list the devices in the “Connected Devices” view.
NOTE
A device that was discovered by the Device search function will disappear from the “Connected Devices” view if the device
does not communicate for a certain period of time. If you want a discovered device to appear continuously in the “Connected
Devices” view, enable keepalive check on the device. For details on keepalive check, refer to the description provided for the
Keepalive check box in 2 List for the “Connected Devices” view (page 30).
1
2
4 73 5 86