User Manual

Installation in a rack

22 SWR2310-28GT SWR2310-18GT SWR2310-10G

2. Install the rack mount panel to the 19-inch rack.

Using the screws that are included with the 19-inch rack (EIA standard 4 pcs., JIS standard

2 pcs.), fasten this unit to the 19-inch rack. Be sure to tighten the screws so that they will not

get loosened.

You can also mount two SWR2310-10G units as shown in the figure below.

Caution

So as not to obstruct the cooling vents on the top panel of this unit, leave a gap when installing

it in a 19-inch rack.

19-inch rack

Rack mount panel

[For an EIA standard rack]

[For a JIS standard rack]

Screws supplied

with the 19-inch

rack

Screws supplied

with the 19-inch

rack

SWR2310-10G