User Manual

English
Installation on a wall or ceiling
SWR2310-28GT SWR2310-18GT SWR2310-10G
25
1. Place the mounting accessory against the wall or ceiling, and mark the
installation location.
2. Provisionally attach four commercially
available screws to the locations that you
marked in step 1.
At this time, leave approximately 2 mm between the
head of the screw and the surface of the wall or ceiling,
allowing room for the mounting accessory to engage the
screws (illustration at right).
Warning
You must use screws that are appropriate for the material of the wall or ceiling.
If the unit falls, injury or damage might occur.
3. Align the unit with the mounting accessory (illustration below).
Notice
If the supplied feet have already been attached to the unit, remove them.
WK-SWRWK-SWR
A
B
C
C
D
D
D
D
B
B
C
C
B
A
A
A
2-R2.5
20
5
ø
10
2-
ø
5.5
SWR2310-18GT/SWR2310-10G
Attachment surface
(not stamped)
Wall installation
surface
(stamped)
Mark the
wall
Approxi-
mately 2 mm
10
9
18
17
B
B
D
D
SWR2310-18GT SWR2310-10G