User Manual

English

Settings

SWR2310-28GT SWR2310-18GT SWR2310-10G

° Logging in from a computer connected to the CONSOLE port

1. Using a console cable, connect this unit to the computer.

Connect the computer to the CONSOLE port of this unit using a USB cable or an RJ-45/DB-

9 console cable.

Notice

• The LAN ports and the RJ-45 CONSOLE port all use the same 8-pin connector. If you

connect these wrongly, hardware damage or malfunction might occur.

Take care when making connections.

• If you use the mini-USB CONSOLE port, do not use a USB hub. If multiple Yamaha

switches are connected to one computer, the COM port numbers assigned to the con-

nection might be inadvertently exchanged. Take care that you are not changing the set-

tings of an unintended unit.

2. Check the power supply of this unit.

If this unit is not powered-on, turn on the power as described in “Turning the power on”

(page 33). When this unit powers-on and the command line is usable, a startup message

appears in the console screen of the computer.

If the power is already on, a startup message does not appear.

3. Press the <Enter> key.

The system waits for a user name to be entered.

If a user name has already been specified, enter the user name.

When the unit is shipped from the factory, a user name has not been specified, so it need

not be entered.

4. Press the <Enter> key.

The system waits for a password to be entered.

If a password has already been specified, enter the password.

When the unit is shipped from the factory, a password has not been specified, so it need not

be entered.

5. Press the <Enter> key.

If password authentication is successful, the command prompt appears, allowing you to

enter commands.

For details on the commands, refer to the command reference.

SWR2310 Rev.2.04.01 (Mon Sep 4 16:28:06 2018)

Reserved.

Username:

Password:

SWR2310>