User Manual

English

Connections

SWR2310-28GT SWR2310-18GT SWR2310-10G

° Making stack connections

Attach a direct attach cable or an SFP+ module (SFP-SWRT-SR or SFP-SWRT-LR) to an

SFP+ port of the SWR2310-28GT. If using an SFP+ module, you must additionally provide a

fiber optic cable that is suitable for the SFP+ module.

For details on installing or removing a direct attach cable, refer to “Installing a direct attach

cable” / (page 32) and “Removing a direct attach cable”

/ (page 32).

For the procedure of installing an SFP+ module, refer to “Installing an SFP module” (page 30).

For details on stack connections, refer to the SWR2310 series “Technical Reference.”

° Turning the power on

1. Attach the included power cord clamp.

To prevent accidental disconnection of the power cord, insert the

included power cord clamp (“included clamp” in the illustration at

right) into the power cord clamp holes of the unit (“holes in the

unit” in the illustration at right) and secure the power cord.

• The included power cord clamp is only for the included

power supply cord.

• If you use the clamp for other power cords, they might be

damaged or might not secure properly.

Connect the included power cord to the power inlet, and secure it with the clamp.

3. Connect the power cord to an electrical outlet.

The POWER indicator flashes green, and after startup is completed, is lit green.

Caution

If the POWER indicator is lit orange, the temperature inside the unit is abnormal.

Reconsider the environment in which this unit is installed, and correctly install this unit so

that its internal temperature is appropriate.

4. Check the port indicators.

If the left indicator (LINK/ACT) of ports connected to a network device or a computer is lit

green or flashing green, the status is normal.

[If the left indicator of the port (LINK/ACT) is not lit green or flashing green]

Check whether the cable is correctly connected to the port, and whether the connected

network device or computer is powered-on.

For details on the connection status, refer to “Port indicators” (page 19).

SWR2310-28GT

SWR2310-18GT

SWR2310-28GT

SWR2310-18GT

Insert the included clamp

into the holes of the unit.

1 Raise the clamp. 2 Connect the power cord. 3 Press down on the

clamp to secure the

power cord.