User Manual

no slave-watch interval
[Parameter]
time : <2-10>
Watch interval (seconds)
[Initial value]
slave-watch interval 3
[Input mode]
L2MS mode
[Description]
Specifies the time interval at which to transmit an L2MS slave query frame.
If this command is executed with the "no" syntax, the setting returns to the default.
If you set time to a high value, the query frame is transmitted less often, but it will take longer from when the L2MS slave is
connected until the L2MS master recognizes it. If you set time to a low value, the opposite will be the case; the query frame is
transmitted more often, but it will take less time from when the L2MS slave is connected until the L2MS master recognizes it.
[Note]
L2MS slave watch is performed only if L2MS is operating as master.
[Example]
Set the watch interval to five seconds.
SWR2311P(config)#l2ms configuration
SWR2311P(config-l2ms)#l2ms enable
SWR2311P(config-l2ms)#l2ms role master
SWR2311P(config-l2ms)#slave-watch interval 5
4.21.5 Set number of times that is interpreted as L2MS slave down
[Syntax]
slave-watch down-count count
no slave-watch down-count
[Parameter]
count : <2-10>
Number of times that is interpreted as down
[Initial value]
slave-watch down-count 3
[Input mode]
L2MS mode
[Description]
Sets the number of query frames that are transmitted without receiving a response frame from the slave until it is determined
that the L2MS slave is down.
If this command is executed with the "no" syntax, the setting returns to the default.
If the number of query frames specified by count have been transmitted without receiving a response frame from the slave, it is
determined that the corresponding L2MS slave is down.
[Note]
If the port to which the L2MS slave is connected is in a link-down state, determining that the L2MS slave is down might take a
shorter time than the setting of this command.
Slave watch is performed only if L2MS is operating as master.
[Example]
Specify "8" as the count used to determine that the slave is down.
SWR2311P(config)#l2ms configuration
SWR2311P(config-l2ms)#l2ms enable
SWR2311P(config-l2ms)#l2ms role master
SWR2311P(config-l2ms)#slave-watch down-count 8
Command Reference | Maintenance and operation functions | 105