User Manual

4.21.6 Set terminal management function
[Syntax]
terminal-watch enable
terminal-watch disable
no terminal-watch
[Keyword]
enable : Enable terminal management function
disable : Disable terminal management function
[Initial value]
terminal-watch disable
[Input mode]
L2MS mode
[Description]
Enables the terminal management function. If this is enabled, information about the devices existing on the network is obtained
at regular intervals.
If this command is executed with the "no" syntax, disable terminal management function.
[Note]
Terminal management is performed only if L2MS is operating as master.
[Example]
Enable the terminal management function.
SWR2311P(config)#l2ms configuration
SWR2311P(config-l2ms)#l2ms enable
SWR2311P(config-l2ms)#l2ms role master
SWR2311P(config-l2ms)#terminal-watch enable
4.21.7 Set the device information acquisition time interval
[Syntax]
terminal-watch interval time
no terminal-watch interval
[Parameter]
time : <1800-86400>
Acquisition interval (seconds)
[Initial value]
terminal-watch interval 1800
[Input mode]
L2MS mode
[Description]
Specifies the time interval at which network device information is acquired. Information for the devices existing on the network
is acquired when the time specified by time has elapsed.
If this command is executed with the "no" syntax, the setting returns to the default.
[Note]
If the terminal management function is not enabled, terminal information is not acquired, regardless of the setting of this
command.
[Example]
Set the watch interval to 3,600 seconds.
SWR2311P(config)#l2ms configuration
SWR2311P(config-l2ms)#l2ms enable
SWR2311P(config-l2ms)#l2ms role master
SWR2311P(config-l2ms)#terminal-watch enable
SWR2311P(config-l2ms)#terminal-watch interval 3600
106 | Command Reference | Maintenance and operation functions