User Manual

4.21.8 Set L2MS control frame transmit/receive
[Syntax]
l2ms filter enable
l2ms filter disable
no l2ms filter
[Keyword]
enable : L2MS control frames cannot be transmitted or received
disable : L2MS control frames can be transmitted or received
[Initial value]
l2ms filter disable
[Input mode]
interface mode
[Description]
Prevents L2MS control frames from being transmitted or received.
If this command is executed with the "no" syntax, L2MS control frames can be transmitted and received.
[Note]
This command cannot be specified for the following interfaces.
•
VLAN interface
•
A physical interface inside a logical interface
A physical interface inside a logical interface operates according to the setting of this command on the interface inside which it
exists. If the physical interface is inside the logical interface, the setting of the physical interface returns to the default.
Regardless of the setting of this command, L2MS control frames might not be transmitted or received if any of the following
conditions exist.
• The interface is in the Blocking status due to STP or the loop detection function
• The switchport trunk native vlan none command has been specified
• It is inside a logical interface
[Example]
Prevent port1.5 from transmitting or receiving L2MS control frames.
SWR2311P(config)#interface port1.5
SWR2311P(config-if)#l2ms filter enable
4.21.9 Reset slave management
[Syntax]
l2ms reset
[Input mode]
priviledged EXEC mode
[Description]
Removes all L2MS slaves managed by the L2MAS master from management, and searches for L2MS slaves once again.
[Note]
This can be executed only if L2MS is operating as master.
When this command is executed, L2MS slaves that were being managed also remove themselves from the state of being
managed by the L2MS master.
After this command is executed, the timing at which L2MS slave watching resumes will depend on the time specified by the
slave-watch interval command.
[Example]
Reset L2MS slave management.
SWR2311P#l2ms reset
Command Reference | Maintenance and operation functions | 107