User Manual

9.1.15 Set VLAN access map filter ....................................................................................................245
9.1.16 Show VLAN access map .........................................................................................................245
9.1.17 Show VLAN access map filter ................................................................................................246
9.2 QoS (Quality of Service) ..........................................................................................................................246
9.2.1 Enable/disable QoS ...................................................................................................................246
9.2.2 Set default CoS ..........................................................................................................................247
9.2.3 Set trust mode ............................................................................................................................247
9.2.4 Show status of QoS function setting .........................................................................................248
9.2.5 Show QoS information for interface .........................................................................................248
9.2.6 Show egress queue usage ratio ..................................................................................................250
9.2.7 Set CoS - egress queue ID conversion table ..............................................................................250
9.2.8 Set DSCP - egress queue ID conversion tabl ............................................................................251
9.2.9 Set port priority order ................................................................................................................252
9.2.10 Specify egress queue of frames transmitted from the switch itself .........................................253
9.2.11 Generate class map (traffic category conditions) ....................................................................253
9.2.12 Associate class map .................................................................................................................254
9.2.13 Set traffic classification conditions (access-list) .....................................................................254
9.2.14 Set traffic classification conditions (CoS) ...............................................................................255
9.2.15 Set traffic classification conditions (TOS precedence) ...........................................................255
9.2.16 Set traffic classification conditions (DSCP) ............................................................................256
9.2.17 Set traffic classification conditions (Ethernet Type) ...............................................................256
9.2.18 13.2.22 Set traffic classification conditions (VLAN ID) ........................................................257
9.2.19 Set traffic classification conditions (VLAN ID range) ............................................................
257
9.2.20 Show class map information ...................................................................................................258
9.2.21 Generate policy map for received frames ................................................................................259
9.2.22 Apply policy map for received frames ....................................................................................259
9.2.23 Set pre-marking (CoS) .............................................................................................................260
9.2.24 Set pre-marking (TOS precedence) .........................................................................................261
9.2.25 Set pre-marking (DSCP) ..........................................................................................................262
9.2.26 Set individual policers (single rate) .........................................................................................262
9.2.27 Set individual policers (twin rate) ...........................................................................................264
9.2.28 Set remarking of individual policers .......................................................................................265
9.2.29 Generate aggregate policer ......................................................................................................266
9.2.30 Set aggregate policer (single rate) ...........................................................................................267
9.2.31 Set aggregate policer (twin rate) ..............................................................................................267
9.2.32 Set remarking of aggregate policers ........................................................................................268
9.2.33 Show aggregate policers ..........................................................................................................270
9.2.34 Apply aggregate policer ..........................................................................................................270
9.2.35 Show metering counters ..........................................................................................................271
9.2.36 Clear metering counters ...........................................................................................................271
9.2.37 Set egress queue (CoS-Queue) ................................................................................................272
9.2.38 Set egress queue (DSCP-Queue) .............................................................................................272
9.2.39 Show policy map information .................................................................................................273
9.2.40 Show map status ......................................................................................................................275
9.2.41 Set egress queue scheduling ....................................................................................................276
9.2.42 Set traffic shaping (individual port) ........................................................................................276
9.2.43 Set traffic-shaping (queue units) .............................................................................................277
9.3 Flow control ..............................................................................................................................................278
9.3.1 Set flow control (IEEE 802.3x PAUSE send/receive) (system) ................................................278
9.3.2 Set flow control (IEEE 802.3x PAUSE send/receive) (interface) .............................................278
9.3.3 Show flow control operating status ...........................................................................................279
9.4 Storm control ............................................................................................................................................280
Command Reference | TOC | 11