User Manual

[Keyword]
enable : Use the L2MS function
disable : Don't use the L2MS function
[Initial value]
config-auto-set enable
[Input mode]
L2MS mode
[Description]
Sets whether to use the L2MS slave device's zero config function.
If the zero config function is enabled, and the L2MS slave's Yamaha switch or wireless AP settings (config) are saved, the
saved settings (config) are automatically applied when the L2MS slave in its factory-set state is connected to the network.
If this command is executed with the "no" syntax, the setting returns to the default.
[Note]
Synchronization of settings for a slave SWR2311P-10G is performed regardless of this setting.
[Example]
Use the L2MS function.
SWR2311P(config)#l2ms configuration
SWR2311P(config-l2ms)#l2ms enable
SWR2311P(config-l2ms)#l2ms role master
SWR2311P(config-l2ms)#config-auto-set enable
4.22 Snapshot
4.22.1 Set snapshot function
[Syntax]
snapshot enable
snapshot disable
no snapshot
[Keyword]
enable : Snapshot function is enabled
disable : Snapshot function is disable
[Initial value]
snapshot disable
[Input mode]
global configuration mode
[Description]
Enables the snapshot function.
If this command is executed with the "no" syntax, disables the snapshot function.
[Note]
This command is valid only if L2MS is operating as master.
[Example]
Enable the snapshot function.
SWR2311P(config)#snapshot enable
4.22.2 Set whether to include terminals in the snapshot comparison
[Syntax]
snapshot trap terminal [except-wireless]
no snapshot trap terminal
Command Reference | Maintenance and operation functions | 111