User Manual

[Input mode]
global configuration mode
[Description]
Sets the time at which the new firmware is applied by restarting after a firmware update.
If this command is executed with the "no" syntax, the new firmware is applied by restarting immediately after the firmware is
updated.
[Example]
Specify AM 1:30 as the restart time for updating the firmware.
SWR2311P(config)#firmware-update reload-time 1 30
SWR2311P(config)#
4.24 General maintenance and operation functions
4.24.1 Set host name
[Syntax]
hostname hostname
no hostname [hostname]
[Parameter]
hostname : Single-byte alphanumeric characters and single-byte symbols (63characters or less)
Host name
[Initial value]
hostname SWR2311P
[Input mode]
global configuration mode
[Description]
Specifies the host name.
The host name specified by this command is used as the command prompt. If SNMP access is possible, this is used as the value
of the MIB variable sysName.
If this command is executed with the "no" syntax, the setting returns to the default value.
[Example]
Set the host name as "yamaha."
SWR2311P(config)#hostname yamaha
yamaha(config)#
4.24.2 Reload system
[Syntax]
reload
[Input mode]
priviledged EXEC mode
[Description]
Reboots the system.
[Note]
If the currently-running settings (running configuration) have been changed from the settings at the time of boot (startup
configuration), reboot will discard those changes. Therefore, if necessary, you should execute the copy running-config
startup-config command or the write command before you execute the reload command.
[Example]
Reboot the system.
SWR2311P#reload
reboot system? (y/n): y
116 | Command Reference | Maintenance and operation functions