User Manual

[Example]
Set the EAPOL packet transmission count for LAN port #1 to "3".
SWR2311P(config)#interface port1.1
SWR2311P(config-if)#dot1x max-auth-req 3
5.3.7 Set the MAC authentication function
[Syntax]
auth-mac enable
auth-mac disable
no auth-mac enable
[Initial value]
auth-mac disable
[Input mode]
interface mode
[Description]
Enables MAC authentication for the applicable interface.
When this command is executed with the "no" syntax or when disable is specified, MAC authentication is disabled.
[Note]
This command can be specified only for both LAN/SFP port and logical interface.
In order to actually use MAC authentication, you need to enable MAC authentication for the entire system as well. (aaa
authentication auth-mac command)
[Example]
Enable the LAN port #1 MAC authentication function.
SWR2311P(config)#interface port1.1
SWR2311P(config-if)#auth-mac enable
5.3.8 Set MAC address format during MAC authentication
[Syntax]
auth-mac auth-user type case
no auth-mac auth-user
[Parameter]
type : Specify the format
Setting value Format
hyphen xx-xx-xx-xx-xx-xx
colon xx:xx:xx:xx:xx:xx
unformatted xxxxxxxxxxxx
case : Specify upper or lowercase
Setting value Description
lower-case Lower case(a～f)
upper-case Upper case(A～F)
[Initial value]
auth-mac auth-user hyphen lower-case
[Input mode]
global configuration mode
[Description]
Changes the format of the user name and password used for authentication during MAC authentication.
146 | Command Reference | Interface control