User Manual

Single-byte alphanumeric characters, and single-byte symbols other than the characters '?' and spaces
(64 characters or less)
[Initial value]
no radius-server key
[Input mode]
global configuration mode
[Description]
Sets the shared password used when communicating with a RADIUS server.
If this command is executed with the "no" syntax, the setting returns to the default.
[Note]
If a server-specific shared password has been set using the radius-server host command, the radius-server host command
settings are used.
[Example]
The shared password used with the RADIUS server is "abcde".
SWR2311P(config)#radius-server key abcde
5.3.22 Set time of RADIUS server usage prevention
[Syntax]
radius-server deadtime time
no radius-server deadtime
[Parameter]
time : <0-1440>
RADIUS server usage prevention time (minutes)
[Initial value]
radius-server deadtime 0
[Input mode]
global configuration mode
[Description]
Sets the time during which the usage of the relevant server is prevented, when a request to the RADIUS server has timed out.
If this command is executed with the "no" syntax, the setting returns to the default.
[Example]
This sets the usage prevention for the RADIUS server to 1 minute.
SWR2311P(config)#radius-server deadtime 1
5.3.23 Set NAS-Identifier attribute sent to RADIUS server
[Syntax]
auth radius attribute nas-identifier line
no auth radius attribute nas-identifier
[Parameter]
line : Identifying text (253 characters or fewer)
The desired text string to be set as the NAS-Identifier attribute
[Initial value]
no auth radius attribute nas-identifier
[Input mode]
global configuration mode
[Description]
Specifies a desired text string that is sent as the NAS-Identifier attribute to the RADIUS server for port authentication.
154 | Command Reference | Interface control