User Manual

If this setting is made, it is notified to RADIUS server as the NAS-Identifier attribute. If this setting is deleted, notification is
stopped.
If this command is executed with the "no" syntax, the setting returns to the default.
[Example]
Set "Nas-ID-001" as the NAS-Identifier attribute that is sent to the RADIUS server.
SWR2311P(config)#auth radius attribute nas-identifier Nas-ID-001
5.3.24 Show port authentication information
[Syntax]
show auth status [interface ifname]
[Keyword]
interface : Show information for only a specified interface
[Parameter]
ifname : Interface name
Interface to show
[Input mode]
unprivileged EXEC mode, priviledged EXEC mode
[Description]
Shows the setting status for port authentication as well as the current authentication state.
[Example]
Show the port authentication information.
SWR2311P#show auth status
[System information]
802.1X Port-Based Authentication : Enabled
MAC-Based Authentication : Disabled
WEB-Based Authentication : Enabled
Clear-state time : Not configured
Redirect URL :
Not configured
Auth-web custom-file :
There is no custom-file
RADIUS server address :
192.168.100.101 (port:1812)
[Interface information]
Interface port1.1 (up)
802.1X Authentication : Auto (configured:auto)
MAC Authentication : Disabled (configured:disable)
WEB Authentication : Disabled (configured:disable)
Host mode : Single-host
Dynamic VLAN creation : Disabled
Guest VLAN : Disabled
Reauthentication : Disabled
Reauthentication period : 60 sec
MAX request : 2 times
Supplicant timeout : 30 sec
Quiet period : 60 sec
Controlled directions : Both (configured:both)
Protocol version : 2
Authentication status : Authorized
Clear-state time : Not configured
Interface port1.4 (down)
802.1X Authentication : Force Authorized (configured:-)
MAC Authentication : Disabled (configured:disable)
WEB Authentication : Enabled (configured:enable)
Host mode : Multi-supplicant
Command Reference | Interface control | 155