User Manual

no power-inline description
[Parameter]
line : Single-byte alphanumeric characters (64 characters or less)
[Initial value]
none
[Input mode]
interface mode
[Description]
Sets the description text of the PD device to connect to PoE port.
[Note]
The description text that was set is shown with the show power-inline command.
[Example]
Set the description of the PD device connected to port1.1 as "AP1".
SWR2311P(config)#interface port1.1
SWR2311P(config-if)#power-inline description ap1
5.6.4 Set PoE port power supply priority
[Syntax]
power-inline priority priority
no power-inline priority
[Parameter]
priority : Power supply priority
Setting value Description
critical Highest
high High
low Low
[Initial value]
power-inline priority low
[Input mode]
interface mode
[Description]
Sets the power supply priority for PoE port.
If the amount of power used by the PoE power supply has exceeded the maximum, power supply will stop for the port with the
lowest priority.
If this command is executed with the "no" syntax, the setting returns to the default.
[Note]
Power supply priority is shown using the show power-inline command.
[Example]
Set the power supply priority for port1.5 to high.
SWR2311P(config)#interface port1.5
SWR2311P(config-if)#power-inline priority high
5.6.5 Guard band settings
[Syntax]
power-inline guardband watts
no power-inline guardband
166 | Command Reference | Interface control