User Manual

Even if multiple VLAN is specified, correct communication might not be possible due to the following.
• Spanning tree block status
•
IGMP snooping or MLD snooping status
• Loop detection block status
[Example]
Assign LAN port #1 to multiple VLAN group #10.
SWR2311P(config)#interface port1.1
SWR2311P(config-if)#switchport multiple-vlan group 10
SWR2311P(config-if)#exit
6.2.17 Set name of multiple VLAN group
[Syntax]
multiple-vlan group group-id name name
no multiple-vlan group group-id
[Parameter]
group-id : <1-256>
Multiple VLAN group ID
name : Single-byte alphanumeric characters and single-byte symbols(32characters or less)
Name of mulitiple VLAN group
[Initial value]
multiple-vlan group group-id name GROUPxxxx (xxxx is the four-digit group ID)
[Input mode]
global configuration mode
[Description]
Sets the name of multiple VLAN group.
If this command is executed with the "no" syntax, the setting returns to the default.
The name that was set is shown with the show vlan multiple-vlan command.
[Example]
Set multiple VLAN group #10 with the name "Network1".
SWR2311P(config)#multiple-vlan group 10 name Network1
6.2.18 Show VLAN information
[Syntax]
show vlan vlan-id
show vlan brief
[Keyword]
brief : Show all VLAN information
[Parameter]
vlan-id : <1-4094>
VLAN ID to show
[Input mode]
unprivileged EXEC mode, priviledged EXEC mode
[Description]
Shows information for the specified VLAN ID.
The following items are shown.
Item Description
VLAN ID VLAN ID
182 | Command Reference | Layer 2 functions