User Manual

Chapter 7
Layer 3 functions
7.1 IPv4 address management
7.1.1 Set IPv4 address
[Syntax]
ip address ip_address/mask [label textline]
ip address ip_address netmask [
label textline]
no ip address
[Keyword]
label : Set label as IPv4 address
[Parameter]
ip_address : A.B.C.D
IPv4 address
mask : <1-31>
Number of mask bits
netmask : A.B.C.D
Netmask in address format
textline : Label (maximum 64 characters)
[Initial value]
ip address 192.168.100.240/24 * VLAN #1 only
[Input mode]
interface mode
[Description]
Specifies the IPv4 address and net mask for the VLAN interface.
IPv4 addresses can be assigned to a maximum of 8 VLAN interfaces.
An IPv4 address can be specified for only one VLAN interface.
If this command is executed with the "no" syntax, the specified IPv4 address is deleted.
If a label is specified, it is shown in the "IPv4 address" field by the show interface command.
[Note]
It is not possible to assign an IPv4 address of the same subnet to multiple interfaces.
[Example]
Specify 192.168.1.100 as the IP address for VLAN #1.
SWR2311P(config)#interface vlan1
SWR2311P(config-if)#ip address 192.168.1.100/24
7.1.2 Show IPv4 address
[Syntax]
show ip interface [interface] brief
[Parameter]
interface : VLAN interface name
[Input mode]
unprivileged EXEC mode, priviledged EXEC mode
204 | Command Reference |
Layer 3 functions