User Manual

1 2001:db8:10::1 (2001:db8:10::1) 0.563 ms 0.412 ms 0.428 ms
2 2001:db8:20::1 (2001:db8:20::1) 0.561 ms 0.485 ms 0.476 ms
3 2001:db8:30::1 (2001:db8:30::1) 0.864 ms 0.693 ms 21.104 ms
4 2001:db8:40::1 (2001:db8:40::1) 0.751 ms 0.783 ms 0.673 ms
5 2001:db8:50::1 (2001:db8:50::1) 7.689 ms 7.527 ms 7.168 ms
6 2001:db8:1::2 (2001:db8:1::2) 33.948 ms 10.413 ms 7.681 ms
7.11 DNS client
7.11.1 Set DNS lookup function
[Syntax]
dns-client switch
no dns-client
[Parameter]
switch : Behavior of the DNS client
Setting value Description
enable Enable the DNS client
disable Disable the DNS client
[Initial value]
dns-client enable
[Input mode]
global configuration mode
[Description]
Enables or disables the DNS lookup function.
If this command is executed with the "no" syntax, the function is disabled.
[Example]
Enable the DNS lookup function.
SWR2311P(config)#dns-client enable
7.11.2 Set DNS server list
[Syntax]
dns-client name-server server
no dns-client name-server server
[Parameter]
server : A.B.C.D
IPv4 addtess of the DNS server
: X:X::X:X
IPv6 address of the DNS server
If you specify an IPv6 link local address, you must also specify the output interface (fe80::X%vlanN
format)
[Initial value]
none
[Input mode]
global configuration mode
[Description]
Adds a server to the DNS server list.
Up to three servers can be specified.
If this command is executed with the "no" syntax, the specified server is deleted from the DNS server list.
220 | Command Reference |
Layer 3 functions