User Manual

[Example]
Enable MLD snooping for VLAN #2.
SWR2311P#configure terminal
SWR2311P(config)#interface vlan2
SWR2311P(config-if)#ipv6 mld snooping enable
Disnable MLD snooping for VLAN #2.
SWR2311P#configure terminal
SWR2311P(config)#interface vlan2
SWR2311P(config-if)#ipv6 mld snooping disable
8.3.2 Set MLD snooping fast-leave
[Syntax]
ipv6 mld snooping fast-leave
no ipv6 mld snooping fast-leave
[Initial value]
none
[Input mode]
interface mode
[Description]
Enables MLD snooping fast-leave for the interface.
If this is executed with the "no" syntax, MLD snooping fast-leave is disabled.
[Note]
This command can be specified only for VLAN interfaces. Also, this can be specified only if MLD snooping is enabled.
Do not enable this command on a VLAN interface for which multiple hosts are connected to the LAN/SFP port.
[Example]
Enable MLD snooping fast-leave for VLAN #2.
SWR2311P#configure terminal
SWR2311P(config)#interface vlan2
SWR2311P(config-if)#ipv6 mld snooping fast-leave
Disable MLD snooping fast-leave for VLAN #2.
SWR2311P#configure terminal
SWR2311P(config)#interface vlan2
SWR2311P(config-if)#no ipv6 mld snooping fast-leave
8.3.3 Set multicast router connection destination
[Syntax]
ipv6 mld snooping mrouter interface ifname
no ipv6 mld snooping mrouter interface ifname
[Parameter]
ifname : Interface name of LAN/SFP port
Interface to set
[Initial value]
none
[Input mode]
interface mode
[Description]
Statically sets the LAN/SFP port to which the multicast router is connected.
If this command is executed with the "no" syntax, the setting is discarded.
[Note]
This command can be specified only for VLAN interfaces. Also, this can be specified only if MLD snooping is enabled.
230 | Command Reference |
IP multicast control