User Manual

SWR2311P(config)#qos disable
9.2.2 Set default CoS
[Syntax]
qos cos value
no qos cos
[Parameter]
value : <0-7>
Default CoS value
[Initial value]
qos cos 0
[Input mode]
interface mode
[Description]
Sets the default CoS of LAN/SFP port and logical interface.
If this is executed with the "no" syntax, the default value (CoS=0) is specified.
The default CoS is used if untagged frames are received when the interface's trust mode is set to CoS. (Since CoS is not
specified for the frame)
[Note]
In order to execute this command, QoS must be enabled.
If this is executed for an interface whose trust mode is CoS, the command results in an execution error.
An LAN/SFP port whose default CoS differs cannot be aggregated as an logical interface.
If the interface for which this is executed is an LAN/SFP port that is associated with an logical interface, then this command
produces an execution error. However, in the case of settings for an LAN/SFP port that is associated with an logical interface in
the startup config, the setting for the lowest-numbered port is applied to the logical interface.
[Example]
Set the default CoS value to 2.
SWR2311P(config-if)#qos cos 2
Return the default CoS value to the default value.
SWR2311P(config-if)#no qos cos
9.2.3 Set trust mode
[Syntax]
qos trust mode
no qos trust
[Parameter]
mode : Trust mode
Setting value Description
cos
Determines the egress queue based on the CoS
value
dscp
Determines the egress queue based on the DSCP
value
port-priority
Applies the specified priority to the receiving
port
[Initial value]
qos trust cos
[Input mode]
interface mode
Command Reference | Traffic control | 247