User Manual

CoS value of conversion source
queue-id : <0-7>
Egress queue ID corresponding to CoS value
[Initial value]
See [Note]
[Input mode]
global configuration mode
[Description]
Specifies the values of the CoS - egress queue ID conversion table that is used to determine the egress queue.
If this is executed with the "no" syntax, the egress queue ID for the specified CoS value is returned to the default setting.
The CoS - egress queue ID conversion table is used when the trust mode is set to CoS.
[Note]
In order to execute this command, QoS must be enabled.
The following table shows the default settings of the CoS - egress queue ID conversion table.
CoS value Egress queue
0 2
1 0
2 1
3 3
4 4
5 5
6 6
7 7
[Example]
Assign egress queue #4 to CoS value "0".
SWR2311P(config)#qos cos-queue 0 4
Return the egress queue ID of CoS value "0" to the default value.
SWR2311P(config)#no qos cos-queue 0
9.2.8 Set DSCP - egress queue ID conversion tabl
[Syntax]
qos dscp-queue dscp-value queue-id
no qos dscp-queue dscp-value
[Parameter]
dscp-value : <0-63>
DSCP value of the conversion source
queue-id : <0-7>
Egress queue ID corresponding to DSCP value
[Initial value]
See [Note]
[Input mode]
global configuration mode
[Description]
Specifies the values of the DSCP - egress queue ID conversion table that is used to determine the egress queue.
If this is executed with the "no" syntax, the egress queue ID for the specified DSCP value is returned to the default setting.
Command Reference | Traffic control | 251