User Manual

9.2.21 Generate policy map for received frames
[Syntax]
policy-map name
no policy-map name
[Parameter]
name : Name of policy map (maximum 32 characters; uppercase and lowercase are distinguished)
[Input mode]
global configuration mode
[Description]
Generates a policy map. The policy map combines the following processing for received frames, for each traffic class.
• Traffic classification
•
Pre-marking
• Metering
• Policing
• Remarking
The policy map generated by this command can be applied to LAN/SFP port and logical interface by the service-policy input
command. This classifies received frames into traffic classes according to each class map in the policy map, and applies the
QoS process specified by the user to each class of traffic.
After generating the policy map, move to policy map mode to specify its content.
If this is executed with the "no" syntax, the specified policy map is deleted.
[Note]
In order to execute this command, QoS must be enabled.
If the specified policy map has already been generated, the change is applied to the previous settings. However, if the policy
map is already applied to LAN/SFP port and logical interface, it cannot be edited or deleted.
[Example]
Make the following settings for received frames to LAN port #1.
• Permit traffic from the 10.1.0.0 network
• Categorize bandwidth classes as CIR:48kbps, CBS:12kbyte, and EBS:12kbyte
• Green: forward, Yellow: rewrite DSCP value to 10, Red: discard
[Traffic class definition]
SWR2311P(config)#access-list 1 permit any 10.1.0.0 0.0.255.255 any
SWR2311P(config)#class-map class1
SWR2311P(config-cmap)#match access-list 1
SWR2311P(config-cmap)#exit
[Policy settings]
SWR2311P(config)#policy-map policy1
SWR2311P(config-pmap)#class class1
SWR2311P(config-pmap-c)#police 48 12 12 yellow-action remark red-action drop
SWR2311P(config-pmap-c)#remark-map yellow ip-dscp 10
SWR2311P(config-pmap-c)#exit
SWR2311P(config-pmap)#exit
SWR2311P(config)#interface port1.1
SWR2311P(config-if)#service-policy input policy1
9.2.22 Apply policy map for received frames
[Syntax]
service-policy input name
no service-policy name
[Parameter]
name : Name of policy map to apply
[Input mode]
interface mode
Command Reference | Traffic control | 259