User Manual

Chapter 4
Maintenance and operation functions
4.1 Passwords
4.1.1 Set password for unnamed user
[Syntax]
password password
no password
[Parameter]
password : Login password for unnamed user
Single-byte alphanumeric characters, and symbols other than the single-byte characters '|', '>', and '?'
(32 characters or less)
The first character must be a single-byte alphanumeric character
[Initial value]
no password
[Input mode]
global configuration mode
[Description]
Sets the password for logging in as an unnamed user.
If this command is executed with the "no" syntax, the unnamed user password for logging is deleted.
[Note]
If the password was encrypted by the password-encryption command, it is shown in the configuration in the form "password
8 password."
The user cannot enter the password in this form when making configuration settings from the command line.
[Example]
Specify user1234 as the unnamed user password.
SWR2311P(config)#password user1234
Delete the unnamed user password.
SWR2311P(config)#no password
4.1.2 Set administrator password
[Syntax]
enable password password
no enable password
[Parameter]
password : Administrator password
Single-byte alphanumeric characters, and symbols other than the single-byte characters '|', '>', and '?'
(32 characters or less)
The first character must be a single-byte alphanumeric character
[Initial value]
no enable password
[Input mode]
global configuration mode
Command Reference | Maintenance and operation functions | 27