User Manual

[Description]
Enable or disable the SD card boot function of the firmware.
After this command is executed, the system will restart.
Since this setting is common to the system, it cannot be specified individually for each startup configuration (startup-config #0
~ strtup-config #4).
By default, SD card boot is enabled.
If this command is executed with the "no" syntax, the setting returns to the default.
[Note]
The SD card boot function enabled/disabled status can be viewed by using the show boot prioritize sd command.
[Example]
Enable the SD card boot function of the firmware.
SWR2311P#boot prioritize sd enable
reboot system? (y/n): y
4.4.4 Show the SD card boot setting information
[Syntax]
show boot prioritize sd
[Input mode]
unprivileged EXEC mode, priviledged EXEC mode
[Description]
Shows the setting of the SD card boot function.
[Example]
Show the setting of the SD card boot function.
SWR2311P#show boot prioritize sd
SD boot configuration:
firmware : enable
4.5 Show unit information
4.5.1 Show inventory information
[Syntax]
show inventory
[Input mode]
unprivileged EXEC mode, priviledged EXEC mode
[Description]
Shows inventory information for this unit and the SFP modules.
The following items are shown.
Item Description
NAME Name
DESCR Description
Vendor Vendor name
PID Product ID
VID Version ID, 0 if invalid
SN Serial number
[Example]
Show inventory information.
SWR2311P>show inventory
NAME: L2 PoE switch
DESCR: SWR2311P-10G
38 | Command Reference | Maintenance and operation functions