User Manual

SWR2311P(config)#ntpdate server ipv6 fe80::2a0:deff:fe11:2233%vlan1
Specify ntp.example.com as the NTP server.
SWR2311P(config)#ntpdate server name ntp.example.com
4.6.5 Synchronize time from NTP server (one-shot update)
[Syntax]
ntpdate oneshot
[Input mode]
priviledged EXEC mode
[Description]
Attempts to obtain time information from the registered NTP server.
This is performed only once when this command is executed.
[Example]
Obtain time information from the NTP server.
SWR2311P#ntpdate oneshot
4.6.6 Synchronize time from NTP server (update interval)
[Syntax]
ntpdate interval interval-time
no ntpdate interval
[Parameter]
interval-time : <0-24>
Interval (hours) for time synchronization. If this is set to 0 hours, periodic synchronization will not
occur.
[Initial value]
ntpdate interval 1
[Input mode]
global configuration mode
[Description]
Specifies the interval (in one-hour units) at which time information is periodically obtained from the registered NTP server.
If this command is executed with the "no" syntax, the setting returns to the default.
When this command is executed, the time is updated immediately, and is subsequently updated at the specified interval.
[Example]
Request the time every two hours.
SWR2311P(config)#ntpdate interval 2
Disable periodic time synchronization.
SWR2311P(config)#ntpdate interval 0
4.6.7 Show NTP server time synchronization settings
[Syntax]
show ntpdate
[Input mode]
unprivileged EXEC mode, priviledged EXEC mode
[Description]
Shows the settings that are related to time synchronization from an NTP server.
44 | Command Reference |
Maintenance and operation functions