User Manual

[Description]
Changes the number of lines displayed per page for the terminal in use.
If line is set to 0, the display is not paused per page.
If the terminal no length command is executed, the number of lines is set to 24 in the case of a serial console, or to the window
size when connected in the case of VTY.
[Note]
When this command is executed, the change applies immediately.
The result of executing this command takes priority over the setting applied by the service terminal-length command.
[Example]
Change the number of lines displayed per page for the terminal in use to 100 lines.
SWR2311P>terminal length 100
SWR2311P>
4.7.5 Set the number of lines displayed per page on the terminal
[Syntax]
service terminal-length line
no service terminal-length
[Parameter]
line : <0-512>
Number of lines displayed per page on the terminal
[Initial value]
no service terminal-length
[Input mode]
global configuration mode
[Description]
Sets the number of lines displayed per page on the terminal.
If line is set to 0, the display is not paused per page.
If this command is executed with the "no" syntax, the number of lines is set to 24 in the case of a serial console, or to the
window size when connected in the case of VTY.
[Note]
After this command is executed, the setting is applied starting at the next login.
If the terminal length command is executed, the result of executing the terminal length command takes priority.
[Example]
Change the number of lines displayed per page for the terminal in use to 100 lines.
SWR2311P(config)#service terminal-length 100
SWR2311P(config)#
4.8 Management
4.8.1 Set management VLAN
[Syntax]
management interface interface
no management interface
[Parameter]
interface : VLAN interface name
[Initial value]
management interface vlan1
Command Reference | Maintenance and operation functions | 47