User Manual

Management interface(vlan): 1

Interface(vlan):1

Access:None

4.15.4 Set hosts that can access the HTTP server

[Syntax]

http-server interface interface

no http-server interface interface

[Parameter]

interface : VLAN interface name

[Initial value]

none

[Input mode]

global configuration mode

[Description]

Sets the VLAN interface that allows access to the HTTP server.

If this command is executed with the "no" syntax, the specified interface is deleted.

This command can be used to specify up to eight items, which are applied in the order that they are specified.

If this command is not set, access is permitted only from the management VLAN.

[Example]

Allow access to the HTTP server from the hosts connected to VLAN #1 and VLAN #2.

SWR2311P(config)#http-server interface vlan1

SWR2311P(config)#http-server interface vlan2

4.15.5 Restrict access to the HTTP server according to the IP address of the client

[Syntax]

http-server access action info

no http-server access [action info]

[Parameter]

action : Specifies the action for the access condition

Setting value Description

deny "Deny" the condition

permit "Permit" the condition

info : Specifies the transmission-source IPv4 address or IPv6 address that is the condition.

Setting value Description

A.B.C.D Specifies an IPv4 address (A.B.C.D)

A.B.C.D/M

Specifies an IPv4 address (A.B.C.D) with subnet

mask length (Mbit)

X:X::X:X Specifies an IPv6 address (X:X::X:X)

X:X::X:X/M

Specifies an IPv6 address (X:X::X:X) with

subnet mask length (Mbit)

any Applies to all IPv4 addresses and IPv6 addresses

[Initial value]

none

74 | Command Reference | Maintenance and operation functions