User Manual

(256 characters or less, single-byte alphanumeric characters and _ - . @)
[Initial value]
no send from
[Input mode]
E-mail template mode
[Description]
Sets the source e-mail address.
[Example]
Specifies “[e-mail]” as the source e-mail address for e-mail template #1.
SWR2311P(config)#mail template 1
SWR2311P(config-mail)#send from [e-mail]
4.19.7 Destination e-mail address setting for e-mail transmission
[Syntax]
send to address
no send to
[Parameter]
address : Destination e-mail address
(256 characters or less, single-byte alphanumeric characters and _ - . @)
[Initial value]
no send to
[Input mode]
E-mail template mode
[Description]
Sets the destination e-mail addresses (maximum of four).
[Note]
This setting is used as the destination for event notifications, and is not used for the destinations when distributing certificates or
sending notifications.
[Example]
Specifies “[e-mail]” as the destination e-mail address for e-mail template #1.
SWR2311P(config)#mail template 1
SWR2311P(config-mail)#send to [e-mail]
4.19.8 Setting for subject used when sending e-mails
[Syntax]
send subject subject
no send subject
[Parameter]
temp-id : Subject used when sending e-mails
(128 characters or less, single-byte alphanumeric characters and symbols other than the characters ? |
>)
[Initial value]
no send subject
[Input mode]
E-mail template mode
[Description]
Specifies the subject for e-mails that are sent.
Command Reference | Maintenance and operation functions | 87