User Manual

[Initial value]
set tx-fast-init 4
[Input mode]
LLDP agent mode
[Description]
Sets the number of LLDP frames transmitted during the high speed transmission period.
If this command is executed with the "no" syntax, the setting returns to the default.
[Example]
Set 2 as the number of LLDP frames transmitted during the high speed transmission period on LAN port #1.
SWR2311P(config)#lldp run
SWR2311P(config)#interface port1.1
SWR2311P(config-if)#lldp-agent
SWR2311P(lldp-agent)#set tx-fast-init 2
4.20.17 Set maximum number of connected devices manageable by a port
[Syntax]
set too-many-neighbors limit max_value
no set too-many-neighbors limit
[Parameter]
max_value : <1-1000>
Maximum number of connected devices manageable by a port
[Initial value]
set too-many-neighbors limit 5
[Input mode]
LLDP agent mode
[Description]
Sets the maximum number of connected devices that can be managed by a port.
If this command is executed with the "no" syntax, the setting returns to the default.
If the maximum number of connected device for a port is exceeded, LLDP frames sent from new devices are ignored.
[Note]
When this command is set, the remote device management table is cleared once when the first LLDP frame is received on the
applicable port.
[Example]
Set 10 as the maximum number of connected devices that can be managed by a port on LAN port #1.
SWR2311P(config)#lldp run
SWR2311P(config)#interface port1.1
SWR2311P(config-if)#lldp-agent
SWR2311P(lldp-agent)#set too-many-neighbors limit 10
4.20.18 Global interface setting for LLDP function
[Syntax]
lldp interface enable type
lldp interface disable
[Keyword]
enable : Enable LLDP function
disable : Disable LLDP function
[Parameter]
type : Transmission/reception mode
98 | Command Reference |
Maintenance and operation functions