User Manual
Table Of Contents
- Yamaha LAN Monitor for Win
- Table of contents
- 1. Introduction
- 2. Installing and uninstalling Yamaha LAN Monitor
- 3. Starting and exiting Yamaha LAN Monitor
- 4. Yamaha LAN Monitor screen structure
- 5. Network settings on the computer
- 6. Basic operation
- 7. Menu bar
- 8. Toolbar and display area
- 9. Map screen
- 10. List screen
- 11. Configuring the device
- 12. Update the firmware
- 13. Import/Export the CONFIG
- 14. Resources
- 15. Troubleshooting
- Yamaha LAN Monitor for Win
5. Network settings on the computer
Configure network settings for your computer.
1. Connect the computer to a network device.
2. Start Yamaha LAN Monitor.
NOTE
If the “User Account Control” dialog box appears, click [Yes].
3.
Click the [Setup] menu on the menu bar → [Open IP Settings for PC].
The “Network Connections” window appears.
4. Right-click the network adapter to which the network device is connected, and click
[Properties].
The “Ethernet Properties” dialog box appears.
5.
Select [Internet Protocol Version 4 (TCP/IPv4)], and click [Properties].
The “Internet Protocol Version 4 (TCP/IPv4) Properties” dialog box appears.
NOTE
If the [Internet Protocol Version 4 (TCP/IPv4)] check box is not selected, make
sure to select it.
6. Set your IP address.
7. Click [OK].
5. Network settings on the computer
14 | Yamaha LAN Monitor for Win User Guide