User Manual

[Input mode]
priviledged EXEC mode
[Description]
Removes all L2MS slaves managed by the L2MAS master from management, and searches for L2MS slaves once again.
[Note]
This can be executed only if L2MS is operating as master.
When this command is executed, L2MS slaves that were being managed also remove themselves from the state of being
managed by the L2MS master.
After this command is executed, the timing at which L2MS slave watching resumes will depend on the time specified by the
slave-watch interval command.
[Example]
Reset L2MS slave management.
SWR2311P#l2ms reset
4.21.10 Show L2MS information
[Syntax]
show l2ms [detail]
[Keyword]
detail : Also show detailed information
[Input mode]
unprivileged EXEC mode, priviledged EXEC mode
[Description]
Shows the following information according to the L2MS operating state.
• If L2MS is operating as master
• Number of L2MS slaves being managed
• Information for the L2MS slaves being managed
• MAC address
• Model name
• Device name
• Route
• Uplink port
• Settings applied
• If L2MS is operating as master and "detail" is specified
• L2MS master information
• Number of terminals connected to the L2MS master
• Information of terminals connected to the L2MS master
• MAC address
• Ports connected
• Time at which terminal was discovered
• Number of L2MS slaves being managed
• Information for the L2MS slaves being managed
• MAC address
• Model name
• Device name
• Route
• Linked-up ports
• Uplink port
• Downlink port
• Settings applied
• Number of terminals connected to the L2MS slave
• Information of terminals connected to the L2MS slave (in the case of a switch)
• MAC address
• Ports connected
• Time at which terminal was discovered
Command Reference | Maintenance and operation functions | 109